Replacing The Installation Gasket - Pro-face SP5000 Series Hardware Manual

Maintenance

Replacing the Installation Gasket

Introduction
The installation gasket provides protection against dust and moisture.
GASKET AGING
Inspect the gasket periodically as required by your operating environment to keep the initial IP

level.
Change the gasket at least once a year, or as soon as scratches or dirt become visible.

Failure to follow these instructions can result in equipment damage.
Installing the Installation Gasket
Stage Description
1 Place the Display Module on a flat, level surface, with the display face pointing down.
2 Remove the gasket from the Display Module.
3 Attach the new gasket to the Display Module. Insert the protrusions from the four corners of the
gasket into the corresponding holes in the corners of the Display Module.
NOTE: When using a tool to insert the gasket, make sure the tool does not catch the rubber
gasket and cause a tear.
1
2
The gasket must be inserted correctly into the groove for moisture resistance for the Display
Module.
EQUIPMENT DAMAGE
Since the gasket is flexible but not elastic, be careful not to stretch it unnecessarily.
Failure to follow these instructions can result in injury or equipment damage.
150
Installation Gasket
Protruding point
NOTICE
CAUTION