Pro-face SP5000 Series Hardware Manual page 115

Removing from the Panel
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
Remove all power from the device before removing any covers or elements of the system, and

prior to installing or removing any accessories, hardware, or cables.
Unplug the power cable from both the Display Module and the power supply.

Always use a properly rated voltage sensing device to confirm power is off.

Replace and secure all covers or elements of the system before applying power to the Display

Module.
Failure to follow these instructions will result in death or serious injury.
EQUIPMENT DAMAGE
When this product is mounted vertically, first remove the Display Module from the panel, then

remove the Box Module from the Display Module.
Keep this product stabilized in the panel-cut while you are installing or removing the screw

fasteners.
Failure to follow these instructions can result in equipment damage.
Step Action
1 Using a Phillips screwdriver, gradually loosen (turn counterclockwise) the screws for the
fasteners (top, bottom, left, and right), alternating diagonally between screws until all screws are
loose.
1
NOTE:


Rear side
For the number of installation fasteners on your model, see Number of Installation Fasteners
in Step 5 of Installing to the Panel (see page 112).
If the panel is thick (approx. 5 mm [0.2 in]), you may have trouble straightening the L-shaped
part of the installation fastener. If this happens, push the display module from the front as you
loosen the screws.
DANGER
NOTICE
SP5000 Series Hardware Manual
115