Connecting The Dc Power Cord - Pro-face SP5000 Series Hardware Manual

Installation and Wiring

Connecting the DC Power Cord

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
Remove all power from the device before removing any covers or elements of the system, and

prior to installing or removing any accessories, hardware, or cables.
Remove power before wiring this product's power terminals.

Always use a properly rated voltage sensing device to confirm power is off.

Replace and secure all covers or elements of the system before applying power to this

product.
Use only the specified voltage when operating this product. The DC unit is designed to use 12

to 24 Vdc power. Always check whether your device is DC powered before applying power.
Since this product is not equipped with a power switch, be sure to connect a power switch to

the power supply.
Be sure to ground this product's FG terminal.

Failure to follow these instructions will result in death or serious injury.
NOTE:
The SG (signal ground) and FG (functional ground) terminals are connected internally in this

product.
When the FG terminal is connected, be sure the wire is grounded. Not grounding this product

can result in excessive electromagentic interference (EMI).
118
DANGER