Connectivity
System Design
Box Module
*1 In order to use this as an isolation port, Isolation Unit is required. To use RS-232C isolation unit,
set the #9 pin of the COM port to VCC.
*2 Refer to Accessories (see page 34).
*3 For information on how to connect controllers and other types of equipment, refer to the
corresponding device driver manual of your screen editing software.
*4 For supported models, refer to Pro-face's support site "Otasuke Pro!"
(http://www.proface.com/otasuke/).
*5 Refer to the Model Numbers (see page 15).
32