Pro-face SP5000 Series Hardware Manual page 105

SP5000 Series Hardware Manual
Check that the installation wall or cabinet surface is flat, in good condition and has no jagged edges. Metal
reinforcing strips may be attached to the inside of the wall, near the panel-cut, to increase its rigidity.
Decide on the thickness of the enclosure wall, based on the level of strength required: 1.6...5 mm
(0.06...0.2 in).
Even if the installation wall thickness is within the recommended range for the "Panel Cut Dimensions",
depending on wall's material, size, and installation location of this product and other devices, the installation
wall could warp. To prevent warping, the installation surface may need to be strengthened.
Be sure that the surrounding air temperature and the ambient humidity are within their designated ranges.
Surrounding air temperature: 0 to 60 C (32 to 140 F) (see the Environment Specifications for this product);
ambient humidity: 10 to 90% RH; wet bulb temperature: maximum 39 C (102 F). When installing this
product in a cabinet or enclosure, the surrounding air temperature is the cabinet's or enclosure's internal
temperature.
Be sure that heat from surrounding equipment does not cause this product to exceed its standard operating
temperature.
When mounting this product vertically, ensure that the right side of this product faces up. In other words, the
DC power connector should be at the top.
1 Power connector
When installing this product in a slanted position, the product face should not incline more than 30.
When installing this product in a slanted position with an incline more than 30, the ambient temperature must
not exceed 40 C (104 F). You may need to use forced air cooling (fan, A/C) to ensure the ambient operating
temperature is 40 C or less (104 F or less).
105