Pro-face SP5000 Series Hardware Manual page 114

Installation and Wiring
Step Action
5 Using a Phillips screwdriver, gradually tighten (turn clockwise) the screws for the fasteners (top,
bottom, left, and right), alternating diagonally between screws until all are secure. Be sure that the
L-shaped part of the installation fastener (2 in figure below) is completely vertical. The necessary
torque is 0.5 N•m (4.4 lb-in).
NOTE:
If the Display Module is not mounted properly, it may fall.

If the panel is thick (approx. 5 mm [0.2 in]), you may have trouble straightening the L-shaped

part of the installation fastener. If this happens, push the display module from the front as you
tighten the screws.
1 Installation fastener
2 L-shaped part of the installation fastener
Number of Installation Fasteners
15-inch models:
Top - 2, Bottom - 2, Right - 2, Left - 2

Models less than 12-inch:
Top - 2, Bottom - 2, Right - None, Left - None

BROKEN ENCLOSURE
Do not exert more than 0.5 N•m (4.4 lb-in) of torque when tightening the fastener's screws.
Failure to follow these instructions can result in equipment damage.
114
NOTICE