Table of Contents
Advertisement
Installation and Wiring
DC Power Supply Connector Specifications: Spring Clamp Terminal Blocks
Models except for SP-5400WA come with the right-angle-type power connector, and the SP-
5400WA comes with the straight-type power connector.
Right-angle type
Connection
+
-
FG
NOTE:
You cannot connect the right-angle type to the SP-5400WA.
Right-angle type: PFXZCBCNDC2 manufactured by Pro-face.
Straight type: PFXZCBCNDC1 manufactured by Pro-face.
How to connect the DC Power Cord
Step
Action
1
Confirm the power cord is not connected to the power supply.
2
Check the rated voltage and remove the "DC24V" sticker on the DC power supply connector.
3
Connect each wire from the power cable to a pin terminal.
4
Push the Opening button with a small and flat screwdriver to open the desired pin hole.
5
Insert each power cord wire into its corresponding hole. Release the Opening button to clamp
the wire in place.
When using stranded wire, do not short with neighboring wires.
6
After inserting all three power cord wires, insert the DC power supply connector into the power
connector on this product.
NOTE: Do not solder the wire directly to the power crimp pin.
120
Straight type
Wire
12...24 Vdc
0 Vdc
Grounded terminal connected to the panel chassis.
Advertisement
Table of Contents
