Table of Contents
Advertisement
Installation and Wiring
Section 6.4
AUX Connector
AUX Connector
Introduction
ELECTRIC SHOCK
Remove the AUX connector from this product prior to wiring.
Strip wires only to the required length.
Do not solder the wire itself.
Failure to follow these instructions will result in death or serious injury.
Step
Action
1
Insert the screwdriver into the opening button. This will open the wire's round-shaped hole.
2
Hold the screwdriver and insert the wire into the wire's round-shaped hole.
3
Take out the screwdriver from the opening button. The round-shaped hole will then close, and
the wire will be held securely in place. To remove the wire, re-insert the screwdriver into the
opening button and when the wire's spring clamp releases, pull the wire out.
4
Insert the wired AUX connector into the Auxiliary Output/Speaker Output Interface (AUX) of this
product.
Recommendations:
AUX Connector: PFXZCDCNAUX1 manufactured by Pro-face
Screwdriver: SZS 0.4 X 2.0 (Product No. 1205202) manufactured by Phoenix Contact
If you use another manufacturer, be sure the part has the following dimensions:
- point depth: 0.4 mm [0.02 in]
- point height: 2.0 mm [0.08 in]
Point shape should have isolation properties meeting DIN 5264 and EN60900.
NOTE:
Wire should be AWG 28 to AWG 20 thick and twisted.
Applicable wire sizes are Style 1015 and Style 1007.
Be sure to strip 8.0 mm (0.31 in) of cover from the wire.
130
DANGER
Advertisement
Table of Contents
