Pro-face SP5000 Series Hardware Manual page 112

Installation and Wiring
RISK OF INJURY
Do not drop the Box Module when you remove it from the Display Module.
Hold the unit in place after removing the fasteners.

Use both hands.

Failure to follow these instructions can result in injury or equipment damage.
Installing to the Panel
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
Remove all power from the device before removing any covers or elements of the system, and

prior to installing or removing any accessories, hardware, or cables.
Unplug the power cable from both the Display Module and the power supply.

Always use a properly rated voltage sensing device to confirm power is off.

Replace and secure all covers or elements of the system before applying power to the Display

Module.
Failure to follow these instructions will result in death or serious injury.
EQUIPMENT DAMAGE
When mounting this product vertically, first install the Box Module onto the Display Module

before attaching the Display Module to the panel.
Keep this product stabilized in the panel-cut while you are installing or removing the screw

fasteners.
Failure to follow these instructions can result in equipment damage.
Step Action
1 When mounting this product vertically, place the Display Module on a clean and level surface with
the screen facing down and mount the Box Module to the Display Module (see page 108).
2 Check that the Display Module's gasket is seated securely into the gasket's groove, which runs
around the perimeter of the display panel frame.
NOTE: Always use the installation gasket, since it absorbs vibration in addition to repelling water.
For the procedure on replacing the installation gasket, refer to Replacing the Installation Gasket
(see page 150).
3 Based on the Display Module's panel cut dimensions (see page 108), open a mount-hole on the
panel and attach the Display Module to the panel from the front side.
112
CAUTION
DANGER
NOTICE