Operation Checking; Fuse Checking - JRC JMA-9133-SA Instruction Manual

>
JMA-9100 Instruction Manual 9.TROUBLE SHOOTING AND AFTER-SALES SERVICE
9.1.2

Operation Checking

When the system is operating, the operation status (located at the upper right of
the screen) is changing pictures.
If picture freeze occurred, turn off the system and restart the system.
9.1.3

Fuse Checking

Melted fuses are caused by any clear cause. When a fuse is replaced, it is
necessary to check the related circuits even if there is no trouble. In checking, note
that there is some dispersion in the fusing characteristics. Table 9-8 shows a list of
fuses used in the equipment.
Location Parts#
AC/DC Converter F501
GYRO Interface
F1 ～ F4
circuit
>
9.1 FAULT FINDING
Operation Status
Table9-9： Fuse List
C u r r e n t P r o t e c t i o n
Rating Circuit
10A Motor
0.5A GYRO
Interface
circuit
9－ 6
Type
ST6-10AN1
MF60NR250V0.5