JRC JMA-9133-SA Instruction Manual page 379

7.2.10.1 Network Function Setting (Network Function)
Turning on/off the network function.
Procedures
Open the Serviceman Menu.
1)
Perfome the following menu open procedure to open the Network
2)
Function setting menu.
3) Select the item
the Network Function.
7.2.10.2 Sensor Priority Setting
The system can receive data from 2 sensors. If the same sentences are received
from 2 sensors, the system use primary system's data.
Procedures
1) Open the Serviceman Menu.
2) Perfome the following menu open procedure to open the Sensor
Priority setting menu.
3) Select the data source sensor for each priority.
1. Primary
2. Secondary
Settable sensors
No.1 ECDIS
No.2 ECDIS
No.3 ECDIS
No.4 ECDIS
No.1 MFD
No.2 MFD
No.3 MFD
No.4 MFD
i. if you selected "None", the system does not receive data.
>
JMA-9100 Instruction Manual
2. Installation Menu
→ 9. Next
→
4. Network
1. Network Function
: The Network Function is operated.
On
: The Network Function is stopped.
Off
2. Installation Menu
→ 9. Next
→
4. Network
→
: High priority sensor (Factory-set:
: Low priority sensor (Factory-set:
No.1 FFD Conning Display
No.2 FFD No.1 Converter Unit
No.3 FFD No.2 Converter Unit
No.4 FFD No.1 Alart I/F
No.1 Chart RADAR No.2 Alart I/F
No.2 Chart RADAR Port Conning
No.3 Chart RADAR STAB Conning
No.4 Chart RADAR No.1 Data Server
7－ 27
7.SETTINGS FOR SYSTEM OPERATION
in the menu, and turn on or off
3. Sensor Priority
No.1 ECDIS
No.2 ECDIS
No.2 Data Server
Console Conning
NAV W/S
No.1 GPS
No.2 GPS
No.3 GPS
No.1 Remote GPS
No.2 Remote GPS
>
7.2 SETTINGS
)
)
No.3 Remote GPS
i
None
7