JRC JMA-9133-SA Instruction Manual page 190

>
JMA-9100 Instruction Manual 3.BASIC OPERATION
4) To add another Waypoint, repeat procedure 3.
To finish adding a Waypoint, left-click twice at the last Waypoint.
5)
The Waypoint adding mode is cancelled.
(Example)
3.7.2.3 Correcting coordinates of a Waypoint (Correct Position)
The coordinates of a Waypoint in the route data saved in the radar system are corrected.
Procedures
1) Open the Set Route Sequence menu by performing the menu
operation below.
2) Left-click the
The Waypoint correcting mode is selected.
3) On the radar display, put the cursor on the Waypoint that is to
have its coordinates corrected, and left-click.
The Waypoint to be corrected is specified.
The cursor display becomes a
>
3.7 USE ROUTE FUNCTION
023
062T
12.0kn
Last Waypoint
Route
→ 2. WPT/Route Setting
→
3. Correct Position
3－ 70
Rubber band
024
3. Set Route Sequence
button.
cursor mark, and a rubber band is displayed.