JRC JMA-9133-SA Instruction Manual page 140

>
JMA-9100 Instruction Manual 3.BASIC OPERATION
3.3.4.5 Entering latitude/longitude
Procedures
1) On the latitude/longitude input screen, sequentially click numeric
buttons to enter latitude (XX°XX．XXX').
For example, to enter 12°34.567', sequentially click numeric buttons as follows.
→
1
To make change between north latitude and south latitude, use
2)
＋
North latitude:Left-click the
South latitude:Left-click the
3) Left-click the
The manually entered latitude value is determined. Then, enter the longitude value.
4) Sequentially click numeric buttons to enter longitude (XXX°XX．
XXX').
5) To make change between east longitude and west longitude, use
＋
East longitude: Left-click the
West longitude: Left-click the
6) Left-click the
The manually entered longitude value is determined.
7) To cancel input, put the cursor on
button.
The latitude/longitude input screen will close without reflecting the set value to the operating
state.
>
3.3 OPERATION PROCEDURES
→ → → →
2 3 4 5
and .
－
＋
－
ENT button.
and .
－
＋
－
ENT button.
3－ 20
→
6 7
button.
button.
button.
button.
and then left-click the
CLR