JRC JMA-9133-SA Instruction Manual page 123

Procedures
1) Check that the ship's mains are turned on.
2) Press [POWER] key.
The system is turned on, and the preheating time is displayed.
Preheat
3) Wait until the preheating time is over.
When the preheating time is over, the preheating time screen disappears, and
at the upper left of the radar display changes to
Press [TX/STBY] key.
4)
The radar will start transmission and the antenna will start rotating.
Standby
NOTE:
JMA-9100 Instruction Manual
is indicated at the upper left of the radar display.
at the upper left of the radar display changes to
The radar does not start transmission if you press [TX/STBY]
Preheat
key while
3－ 3
> >
3.BASIC OPERATION 3.1 OPERATION FLOW
.
Standby
Transmit
is indicated.
3
Preheat
.