JRC JMA-9133-SA Instruction Manual page 365

3) Set the baud rate of the port to be set.
1. COMPASS
2. MAINTENANCE/LOG： 1200/4800/9600/38400 bps
3. NAV1：
4. NAV2：
5. ALARM：
6. JARPA
7. AIS：
8. ARPA
9. COM
i. The compass port is a receive-only port that is dedicated to COMPASS signals.
ii. The bold values are factory-set.
iii. The JARPA port is a transmit-only port that is dedicated to JRC ARPA signals.
iv. The ARPA port is a transmit-only port.
v. The COM port connector is D-sub 9pin.
7.2.1.2 Reception Port Setting(RX Port)
Set the numbers of ports for receiving signals from sensors.
There are two methods for receiving signals: specifying a port for each sensor, or
using the automatic recognition function without specifying ports.
Procedures
Open the Serviceman Menu.
1)
2) Perform the following menu open procedure to open the RX Port
setting menu.
→
Set a port for each sensor.
3)
Settable sensor
Selectable ports When the automatic recognition
>
JMA-9100 Instruction Manual
i
4800(NMEA)/9600(NSK)/38400(fast NMEA)
：
1200/4800/9600/38400 bps
1200/4800/9600/38400 bps
1200/4800/9600/38400 bps
iii
1200/4800/9600/38400 bps
：
1200/4800/9600/38400 bps
iv
1200/4800/9600/38400 bps
：
v
1200/4800/9600/38400/115200 bps
：
2. Installation Menu
5. COM Port Setting
→ 2. RX Port
GPS、 DLOG、 Alarm、 Depth、 Temperature、 Wind、 Current、
signals
ROT、RSA
When ports are specified: L O G 、N A V 1 、N A V 2 、
7－ 13
7.SETTINGS FOR SYSTEM OPERATION
AUTO
function is used:
ALARM、COM
>
7.2 SETTINGS
ii
bps
7