JRC JMA-9133-SA Instruction Manual page 189

Procedures
Open the Set Route Sequence menu by performing the menu
1)
operation below.
2) Left-click the
Confirmation Window will appear.
3) Left-click the
The saved route data will be deleted.
3.7.2.2 Adding a Waypoint (Add Waypoint)
New Waypoint data is added to the route data saved in the radar system.
Procedures
1) Open the Set Route Sequence menu by performing the menu
operation below.
2) Left-click the
The Waypoint adding mode is selected.
The rubber band from the last Waypoint to the cursor position will be displayed on the radar
display.
Left-click the location at which you want to add a Waypoint.
3)
A Waypoint will be added.
When a Waypoint is added, the value of the Planned Speed in the section up to the menu is
used for the Planned Speed value up to the added Waypoint.
JMA-9100 Instruction Manual
Route
→
2. WPT/Route Setting
→ 3. Set Route Sequence
7. New Monitor Route
button.
1. Yes
Route
→ 2. WPT/Route Setting
→ 3. Set Route Sequence
button.
2. Add
3－ 69
> >
3.BASIC OPERATION 3.7 USE ROUTE FUNCTION
button.
3