JRC JMA-9133-SA Instruction Manual page 425

JMA-9100 Instruction Manual
4) Remove the cables connected to the modulator and
the screws on the outside of the modulator (four M4
screws) and slide the modulator to the right to remove
it.
5) Remove the screws (six M4 screws) and take off the
modulator cover.
6) Remove the screws holding the cables
(two M4 screws) and the screws holding
the magnetron (four M4 screws) and
remove the metal fitting and the
magnetron.
Use a non-magnetic screwdriver. If the
magnetron comes into contact with any
metal (tool), its performance may
deteriorate.
>
8.COUNTERMEASURE FOR TROUBLE ...
Green cable
Yellow cable
8－ 27
>
8.4 REPLACEMENT OF MAJOR PARTS
Modulator
Remove the four
outside screws.
Remove the six screws.
Remove the two screws.
Remove the four screws.
8
Magnetron