Print Server Mode - Toshiba GL-1010 Administrator's Manual

10 In the
created (Step 1 on page 158), for example, GL_2_PS.
11 In the
created (Step 3 on page 158).
For Bindery mode, the number is between
number is between
12 Scroll to the bottom of the page, then click
13 Proceed to

Print Server Mode

Considerations and Limitations
You must enable IPX/SPX protocol before running the controller in
print server mode.
You cannot attach any other printers to a controller running in print
server mode. This supersedes the 255-printer limit imposed by
NetWare.
Prerequisites
Use the NetWare management utility PCONSOLE (for NetWare 4.x bindery
mode) or NWAdmin (NetWare 4.x, 5.x, or 6.x NDS mode) to perform the
following steps before enabling Novell print services through TopAccess.
Note: When using NetWare PCONSOLE version 4.x.x., toggle between
NDS and Bindery modes using the F4 key.
For more information, refer to your Novell NetWare documentation.
1 Create a new print server (PSERVER) on the Novell file server.
2 Create a new print queue (e.g., GL_2_Q).
3 Create the printer (e.g., GL_2_PR) and select
Printer Type
4 Assign the print queue to the printer.
5 Assign the printer to the print server. Note the printer number.
Print Server Setup
Set Protocol
1 Launch your Web browser.
160
field, enter the name of the print server you
Print Server Name
field, enter the number assigned to the printer you
Printer Number
and
0
Installing Client Software
.
0
.
254
on page 229.
GL-10x0
and ; for NDS mode, the
15
.
Save
for the
Other/Unknown
Administrator's Guide