Test Print Mode (Test Mode 07) - Toshiba e-STUDIO163 Service Handbook

2.2.3

Test print mode (Test mode 07)

The embedded test pattern can be printed out by keying in the following codes in the test print mode
(07).
<Operation procedure>
[0][7] Code
[POWER]
[Digital keys]
Notes:
1. When an error occurs, it is indicated on the panel, but the recovery operation is not per-
formed. Turn OFF the power and then back ON to clear the error.
2. During test printing, the [CLEAR] button is disabled when the "Adding toner" LED on the con-
trol panel light.
Code Types of test pattern
111 Primary scanning direction 33 gradation steps
113 Secondary scanning direction 33 gradation steps
142 Grid pattern
December 2005 © TOSHIBA TEC
Paper source
[START]
[DRAWER]
Error diffusion
Error diffusion
Pattern width: 2 dots, Pitch: 10 mm
e-STUDIO163/203 ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 11
Continuous
Test Printing
[START]
Stop
[POWER]
[FUNCTION
OFF/ON
CLEAR]
Remarks
2