Toshiba GL-1010 Administrator's Manual page 138

5 Select either
Note: If DHCP is selected, the
are not displayed.
6 Enter the
7 Enter the address of the
8 Enter the address of a
9 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Controller
Configuring DDNS
Dynamic DNS services allow a DHCP server to set the device Host Name
at the same time that it sets the IP address, gateway, and other
parameters. For those sites with large numbers of printers, DDNS allows
new printers to be configured automatically.
To configure DDNS:
1 Log in as an administrator.
2 On the Administration tab, click the
opens.
3 Click the
4 In the DDNS area, click the down arrow beside the
Dynamically
5 Select
6 Enter the host name of the DNS server in the
is disabled if DDNS is disabled. The default value for this field is the
MAC address of the controller.
7 Scroll down to the bottom of the page and click
settings.
Alternatively, click
values.
8 Reboot the controller for the changes to take effect.
For information on rebooting the controller, see
Controller
116
or
Static IP DHCP
,
IP Address Subnet Mask
Secondary DNS Server
on page 43.
link. The network page opens.
Network
pull-down list box.
to enable DDNS or
Enable
Reset
on page 43.
. The default setting is
,
IP Address Subnet Mask
, and
Gateway Address
.
Primary DNS Server
Setup
to disable DDNS.
Disable
to reset all settings on this page to the default
GL-10x0
.
DHCP
, and
Gateway
if appropriate.
.
Rebooting the
subtab. The Setup page
Update DNS
field. This field
Host Name
to save your
Save
Rebooting the
Administrator's Guide
fields