Setting Up A Wireless Network - Toshiba GL-1010 Administrator's Manual

Setting up a Wireless Network

Note: The Cisco Wi-Fi NIC does not support Extensible Authentication
Protocol (EAP).
Install the wireless NIC and press the F
initialize the controller for both the wireless and embedded Ethernet
NICs.
The
WIRELESS
settings in TopAccess are only visible when a Wireless NIC is installed.
The following instructions assume that the controller has been updated
with the latest version of the software.
User Interface Settings
The following table shows the user interface options for configuring
wireless networking from the copier control panel and the Administration
tab of the web-based TopAccess utility.
UI Controls
Data Rate
SSID
Network Type
WEP Security
WEP Encryption
WEP Key (40 bit)
WEP Key (128 bit) Text Field
Authentication
Default Access
Point
Channel
Data Retries
Fragment
Threshold
RTS Threshold
RTS Retry Limit
Transmit Power
Administrator's Guide
GL-10x0
button on the copier LCD touch screen and the wireless
Wireless Networking User Interface Options
Type of Control
Control Panel
Text Label in status Text label
area of front panel
Text field Text field
Option button List box
Option button Check box
Option button List box
Text Field Text Field
Text Field
Option buttons List box
Text Field Text Field
Text Field List box (Ad Hoc)
Text label
(Infrastructure)
Text Field Text Field
Text Field Text Field
Text Field Text Field
Text Field Text Field
Option buttons Combo
ACTORY
TopAccess
11, 5.5, 2, 1
up to 32 characters
Infrastructure/Ad Hoc X
Enabled/Disabled
40 Bits/ 128 Bits
5 * 2 hex characters
13 * 2 hex characters
Open/Shared
6 * 2 hex
(Infrastructure)
Numeric (1-11)
6 (2427 MHz)
Numeric (0-2312)
Numeric (256-2312)
Numeric (1-2312)
Numeric (1-128)
1, 5, 20, 30, 50, 100
button to
D
EFAULTS
Value Read
X
X
X
X
X
X
X
X
X
X
X
X
Write
X
X
X
X
X
X
X
X
X
X
X
X
X
X
143