Toshiba GL-1010 Administrator's Manual page 139

Configuring SMB Settings
If you are using the SMB networking protocol for any network traffic
involving the controller, you must enable the SMB protocol on the
controller. The SMB protocol is disabled by default. If you are not using
SMB for any network traffic, disabling the SMB protocol on the controller
reduces overhead and improves efficiency.
1 Log in as an administrator.
2 In the SMB area of the Network page, click the
3 Select
4 In the
5 Enter the controller
6 Enter the address of the
7 Enter a
Note: Macintosh and Unix networks must have WINS or NETBIOS
support to access the GL-1020 controller by name instead of IP
address.
8 To set the controller as a master browser, click the
down list and select
9 Click
10 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Controller
Configuring AppleTalk Settings
If you are using the AppleTalk networking protocol for any network traffic
involving the controller, you must enable the AppleTalk protocol on the
controller. The AppleTalk protocol is enabled by default. If you are not
using AppleTalk for any network traffic, disabling the AppleTalk protocol
on the controller reduces overhead and improves efficiency.
1 Log in as an administrator.
2 On the Administration tab, click the
3 Click the
4 In the AppleTalk area, click the
5 Select
Administrator's Guide
GL-10x0
to enable SMB protocol. This is the default setting.
Enable
field, enter the controller name.
Device Name
Workgroup
for the controller.
WINS Scope ID
Enable
.
Save
on page 43.
link. The Network page opens.
Network
to enable AppleTalk. This is the default setting.
Enable
in the appropriate field.
.
Primary WINS Server
. The default setting is
Setup
drop-down list.
Protocol
drop-down list.
Protocol
Master Browser
.
Disable
Rebooting the
subtab.
drop-
117