Toshiba GL-1010 Administrator's Manual page 69

4 Press
5 Insert the e-STUDIO Recovery CD-ROM into the controller CD drive
and then press
Version screen.
6 Confirm that the Current OS and New OS versions are correct.
7 Press
8 A message is displayed, prompting you to confirm that you want to
reboot the controller.
9 Press
are backed up and then the controller reboots to CD-ROM mode. The
touch screen displays the OS Update Version screen. Note that the
controller is now offline.
If the touch screen does not display the OS Update Version screen,
the controller did not boot off the CD successfully.
10 Press
the CD to the hard drive. This process takes approximately seven
minutes, during which time the touch screen displays the OS Update
Progress screen.
11 When the system update process completes, the CD-ROM is ejected
and the touch screen displays the message Press the START key
to start controller.
12 Remove the CD-ROM from the drive and press the
must remove the CD-ROM before the controller can boot up.
13 After boot up, an initialization process begins. This takes
approximately 10 minutes. During that time, the touch screen
GL-10x0 Administrator's Guide
to display the System Update menu.
SYSTEM UPDATE
System Update Menu
UPDATE OS
to continue.
OK
to continue with the update. The existing system settings
YES
to continue. The controller begins copying the software from
OK
. The touch screen displays the OS Update
button. You
START
47