Configuring Network Access For Ports - Edge-Core ECS4510-12PD Web Management Manual

Configuring Network
Access for Ports
Web Interface
To configure aging status and reauthentication time for MAC address
authentication:
1.
Click Security, Network Access.
2.
Select Configure Global from the Step list.
3.
Enable or disable aging for secure addresses, and modify the reauthentication
time as required.
4.
Click Apply.
Figure 171: Configuring Global Settings for Network Access
Use the Security > Network Access (Configure Interface - General) page to
configure MAC authentication on switch ports, including enabling address
authentication, setting the maximum MAC count, and enabling dynamic VLAN or
dynamic QoS assignments.
Parameters
These parameters are displayed:
◆
MAC Authentication
Status – Enables MAC authentication on a port. (Default: Disabled)
■
■ Intrusion – Sets the port response to a host MAC authentication failure to
either block access to the port or to pass traffic through. (Options: Block,
Pass; Default: Block)
Max MAC Count
■
be authenticated on a port via MAC authentication; that is, the Network
Access process described in this section. (Range: 1-1024; Default: 1024)
◆
Network Access Max MAC Count
addresses that can be authenticated on a port interface via all forms of
5. The maximum number of MAC addresses per port is 1024, and the maximum number of secure
MAC addresses supported for the switch system is 1024. When the limit is reached, all new MAC
addresses are treated as authentication failures.
Network Access (MAC Address Authentication)
5
– Sets the maximum number of MAC addresses that can
5
– Sets the maximum number of MAC
– 271 –
Chapter 12
| Security Measures