Feeder - Canon iR5000i Service Manual

4.2 FEEDER

DOCST
Use it to adjust the original leading edge registration when the ADF is se-
lected as the source of paper.
• A higher setting decreases the leading edge margin.
• The data will be stored on the ADF controller PCB.
Range of -10 to +10 (unit: 0.5 mm)
adjustment
Using the Mode
1) Make a print of the test chart, and check the position of the image.
2) Select the mode item, and change the setting to make adjustments.
3) Press the OK key.
4) Make a print of the test chart once again, and check to see the position of
the image is as indicated.
LA-SPEED
Use it to adjust the original feed speed for ADF stream reading speed.
• A higher setting increases the speed.
• The data will be stored on the ADF controller PCB.
Range of -30 to +30 (unit: 0.1%)
adjustment
COPYRIGHT © 2001 CANON INC.
Feed direction
Higher setting
2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001
CHAPTER 5 SERVICE MODE
Print image
Lower setting
F05-402-01
COPIER>ADJUST
5-57 T