CHAPTER 3 STANDARDS AND ADJUSTMENTS
7.3 When Replacing the Main Controller PCB
1) Using the Service Support Tool, back up the data by copying.
2) Replace the main controller PCB.
3) Remove the counter memory PCB, boot ROM, and SDRAM from the existing PCB, and
mount them to the new PCB.
4) After assembling the machine, connect the power plug to the power outlet; then, while
holding down the '2' and '8' keys in the control panel at the same time, turn on the main
power switch.
5) Return the data.
7.4 When Replacing the HDD Unit
When replacing the HDD unit, be sure to keep the following in mind:
1. Take appropriate measures against static charges.
2. Keep the HDD unit protected from impact.
1) Replace the HDD unit.
2) After assembling the machine, connect the power plug to the power outlet.
3) Connect a PC to which the Service Support Tool has been installed.
4) Turn on the PC, and turn on the main power switch while holding down both '2' and '8'
on the keypad.
5) Using the Service Support Tool, format the HDD unit and install the system software.
3-26 T
COPYRIGHT © 2001 CANON INC.
2000 2000 2000 2000
CANON iR5000i/iR6000i REV.0 JUNE 2001