Others - Canon iR5000i Service Manual

CHAPTER 4 IMAGE FORMATION SYSTEM

3.4.4 Others

COPIER>ADJUST>HV-TR>PRE-TR (entering the output adjustment
value of pre-transfer charging wire current)
Enter the value indicated on the service label if the RAM on the DC con-
troller PCB has been cleared.
COPIER>ADJUST>HV-TR>H-PRE-TR (entering the offset value of
pre-transfer high-voltage output for high-voltage unit)
Enter the value indicated on the label attached to the new high-voltage unit
if the RAM on the DC controller PCB has been cleared or the high-voltage
unit has been replaced.
COPIER>ADJUST>HV-TR>D-PRE-TR (entering offset value of pre-
transfer high-voltage output of DC controller PCB)
Enter the value indicated on the label attached to the new DC controller
PCB if the RAM on the DC controller PCB has been cleared or the DC
controller PCB has been replaced.
COPIER>OPTION>BODY>W-CLN-P
Set the intervals at which auto cleaning of the primary charging wire is ex-
ecuted in terms of the number of prints.
4-26 P
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001