Canon iR5000i Service Manual page 89

Step
5 Open the hopper cover[6], and
remove the three screws[7] and
connector cover[8]; then discon-
nect the connector[9].
6 Slide out the hopper unit to the
front, and turn it to the front right
by 90°.
7 Loosen the screw[10]; then shift
the charging assembly fixing
member[11] in the direction of
the arrow (right upper), and se-
cure it in place with a screw.
Disconnect the connector[12],
and take out the primary charg-
ing assembly[13].
Check the primary charging as-
sembly; if dirt or paper lint are
found, clean it with alcohol.
8 Disconnect the connector[14],
and remove the screw[15]; then
take out the pre-transfer charging
assembly[16].
Check the pre-transfer charging
assembly; if dirt or paper lint are
found, clean it with alcohol.
COPYRIGHT © 2001 CANON INC.
Work
2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001
CHAPTER 3 INSTALLATION
Checks/remarks
[7]
[6]
[7]
[8]
[9]
[10] [11]
[12] [13]
[15] [16] [14]
3-15 S