Routing The Lifter Cable - Canon iR5000i Service Manual

Hide thumbs Also See for iR5000i:
Table of Contents

Advertisement

3.3.6 Routing the Lifter Cable

1) Check to make sure that the lifter drive shaft and the lifter are held in place with a hex
wrench [1] and long screwdrivers [2].
2) Secure the cable fixing plate [3] to the lifter with two screws.
3) Hook the lifter cable on the pulley [4].
4) Hook the ball of the lifter cable on the pulley [5] of the lifter drive shaft; then, wind the
cable along the groove of the pulley about 1.5 times by hand. At this time, try to keep
the lifter cable taut, i.e., the long screwdrivers used to hold the lifter in position are lifted
slightly by the lifter cable.
5) Secure the pulley to the lifter drive shaft with two set screws [6].
6) Secure all pulleys you have removed to the lifter drive shaft; then, measure the distance
from the base plate of the compartment to the top surface of the lifter, thereby making
sure that the lifter is level.
[3]
COPYRIGHT © 2001 CANON INC.
[3]
[4]
[6]
[5]
[1]
[3]
F08-303-14
2000 2000 2000 2000
CANON iR5000i/iR6000i REV.0 JUNE 2001
CHAPTER 8 PAPER DECK
[4]
(rear)
[5]
[6]
[3]
[2]
8-37 P

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ir6000iImage reader-a1

Table of Contents