Canon iR5000i Service Manual page 813

CHAPTER 5 SERVICE MODE
FUZZY
Use it to turn on/off fuzzy control and to make environment settings.
• The selection will affect pre-transfer, transfer, and separation charging
• Selecting 1 through 3 will make the operation independent of the envi-
Settings 0: fuzzy control ON (default), 1: low humidity environment mode (cur-
rent level lower than standard),
2: normal humidity environment mode, 3: high humidity environment
mode (current level higher than standard)
TSPLY-SW
Use it to switch the toner supply sequence executed in conjunction with the
humidity sensor.
Settings 0: changes control of toner supply motor by humidity data automati-
cally (default)
• medium/low humidity: ON for 2 sec, OFF for 1 sec
• high humidity: ON for 4 sec, OFF for 2 sec
1: uses fixed pattern (ON for 2 sec, OFF for 1 sec)
SCANSLCT
Use it to turn on/off the ADF original size detection mechanism.
• When ON, the scan size is determined according to the detected original
Settings 0: OFF (default), 1: ON
OHP-TEMP
Use it to switch the temperature setting for transparency mode.
• The control mechanism will use a lower fixing temperature to improve
Caution This mode is disabled if WARM-UP, FSPD-S1 is set.
Settings 0: OFF (default)
1: normal temperature control -5°C
2: normal temperature control -10°C
3: normal temperature control -15°C
4: normal temperature control -20°C
F-GD-CNT
Use it to select the descent mode for the fixing inlet guide.
• Move down the inlet guide if uneven density or light images occur as a
Settings 0: normal control (default)
1: moves down inlet guide for 1st side only (A4R/297 mm or larger)
5-80 T
currents.
ronment sensor.
size.
separation of transparencies from the fixing roller.
result of uneven fixing.
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001
COPIER>OPTION