Table of Contents
Advertisement
Action: Sets up the stream to use for recording (network cameras only) or the recording settings (network
video transmitters only). You can set up more than one recording setting for the same recording type.
This function is supported only for devices which use the iNEX protocol.
Target: Sets up the cameras to be recorded.
NOTE: In the schedule setup, "Preset" indicates a single setting in which the setting values of Time Coverage,
Condition or Action are saved.
Setting up Time-Lapse Recording
During Time-Lapse recording, the recording service performs recording continuously based on the schedule
settings for the scheduled time (supported only for devices registered on one of recording services).
1. Set up the schedule time by double clicking the Time Coverage schedule window, and then selecting
a desired Preset.
You can add a new Preset or edit a saved Preset by clicking the Add or Modify button. Refer to the
following explanation for setting up a schedule.
Time: Set up the schedule time.
Repeat, Repeat Period: Set up the recording interval and interval period. The recording service
will perform recording at the designated interval during the interval period.
2. Set the recording mode to the Time-Lapse Recording mode by double clicking the Condition schedule
window and selecting a desired Preset of time condition.
Name: Enter the Preset name.
Color: Click the button and select a desired color. The
scheduled time section will be highlighted with the
selected color in the schedule table.
Period: Set up the schedule time. Selecting the Infinite
option causes continuous recording based on the
Condition, Action and Target preset settings without
limiting the period.
Network Video Recorder
57
Advertisement
Table of Contents
