Eneo PNR-5216 Operating Instructions Manual page 115

NOTES:
 If you remove a device for which some recording has been done and register the device again, the NVR
system considers the device as a new device. In this case, you can search or play back video recorded
before the device was removed as follows: go to the Play or DVR Search panel
→
Menu) button select Removed Devices.
 Recording is not supported for DVRs.
2. Select the Storage Setup tab and click the Setup button.
 Clear All Recorded Data: Deletes all recorded data on all hard disk drives used in the NVR system.
 Delete Recorded Data Partially: Allows you to delete recorded data for a specific period for each device.
Recording will stop while data is being deleted.
 Reconstruct Abnormal Recorded Timetable: When the network connection between the NVR system
and the devices is too slow or a hard disk drive in the NVR system is damaged, the recorded data and
the timetable information of the recorded data might not match and the timetable in the Client program
might display incorrect information. In this situation, clicking the button reconstructs the timetable to
display recorded data correctly on the timetable in the iNEX Client program.
 Overwrite recorded data when the disk is full: Checking the box records over the oldest video data
once all available storage space has been used.
CAUTION: The deleted data cannot be restored.
Network Video Recorder
→
click the (Additional
107