Table of Contents
Advertisement
User's Manual
Clicking the OK button completes the device group registration.
5. Check that the device was added to the device group correctly. Click Device Group in the Site panel
and then the arrow button (
of devices added to the device group and connection status in the Site List panel. If the connection was not
made properly, the network disconnection log is displayed (only for devices registered on the recording
service). Refer to Appendix – Network Disconnection Log (p. 145) for details about the network
disconnection log.
Selecting the registered device group, and then the
the Edit Device Group window and allows you to edit the selected device group. Refer to Chapter 11
— Device Management (p. 87) for details.
2.4 Live Video Monitoring
1. Check that the devices were added to a device group in the
Site list.
2. Click the Live tab on the tab panel → Select a site to connect
to from the Site list, and drag and drop it on the Live screen.
Live video from the selected site is displayed on the screen.
Refer to Chapter 4 — Live Video Monitoring (p. 41) for
details.
2.5 Recording
Run the Setup program. Select the Recording Schedule menu and set up the recording schedule following
the procedures below. Refer to 5.1 Setting up Recording Schedule (p. 55) for details.
16
) beside Device Group. Clicking the registered group displays the list
button at the bottom of the Site List panel displays
Advertisement
Table of Contents
