Table of Contents
Advertisement
User's Manual
Chapter 7 — Event Handling
You can monitor video from a camera where an event is detected and play back event-recorded video. Event
related functions may not be supported depending on the protocol that the device uses (supported for the
iNEX protocol and some versions of the ONVIF
First, check the following.
Devices should be added to a device group. Refer to Chapter 11 — Device Management (p. 87) for
details.
There should be recorded data in the allocated storage. Refer to Chapter 13 — Storage Management
(p. 105) for details.
The event detection functions of the device should be enabled.
7.1 Handling a Monitoring Event
You can monitor live video from a camera where an event is detected or play back event-recorded video
if video of the selected event has been recorded.
Motion Detection
Object Detection
Trip-Zone
/
Alarm-In On/Off
/
Device Connected/Disconnected
System Alive
Recorder Bad
Disk Full
Disk Temperature
Monitoring Video
Monitoring video from a camera where an event is detected is supported in the Live panel (maximum 4).
If a Live tab is not on the tab panel, go to the System menu, click New Tab and Live.
78
The event list displays live and callback events from the registered devices. The
callback events are listed only when the remote callback function is set up in the
device.
You can change the options of the event list display during Menu – Preference
Settings. Refer to 3.3 Client, Menu – Preference Settings (p. 34) for details.
The description of event icons which are displayed in the event list is as follows
(some event icons may not be supported, depending on the specifications and version
of the device):
Video Blind
Audio Detection
Tampering
/
Alarm-In Bad/Good
System Restart
Disk S.M.A.R.T.
Disk Almost Full
/
Panic Recording On/Off
TM
Conformance and Axis protocol).
/
Video Loss
Video Analytics Detection
Text-In
External Storage In/Out
System Boot Up
System Shut Down
Disk Bad
Disk Config Change
/
Fan Error On/Off
Advertisement
Table of Contents
