Table of Contents
Advertisement
−
Device Group: Select to record video when the user-
defined types of events are detected in the selected
device group.
Click Device Group, and the list of registered device
groups is displayed → Under Device Group, click
a device group to trigger event recording, and the
list of event types is displayed in Event Types below
→ Select the desired event types, and the selected
event types are added along with the selected device
group to the list under Device Group on the right.
Pre-Event Recording Condition
The recording service records video prior to event detection when predefined events are detected (supported
only for devices which use the iNEX protocol).
3. Double click the Action schedule window, and then selecting a desired Preset (supported only for devices
which use the iNEX protocol).
4. Select the cameras to record after double clicking the Target schedule window.
Enter the Preset name and select Pre
Event Condition from the Condition
Type list.
A stream to use for recording (network cameras only) or a
codec, resolution, frame rate and quality setting values
(network video transmitters only) are allocated to each
Preset. The stream or setting values allocated to each Preset
is different depending on the device. Refer to 11.2
Managing Devices, Editing Device Information (p. 92)
for details.
Duration: Set up the duration (maximum of 60 seconds)
of recording when a predefined event is detected. For
Event recording, the system records video for the
duration from the time an event is detected. For Pre-Event
recording, the system records video for the duration prior
to event detection.
Network Video Recorder
61
Advertisement
Table of Contents
