Table of Contents
Advertisement
User's Manual
You can upgrade software of several devices at the same time. Clicking the
button above the Site panel displays the following screen (supported only for devices which use the iNEX
protocol).
Checking Device Status
Click All Devices in the Site panel and then a device in the Site List panel. The device status is displayed in
the Recording Status field (Connected: Recording is available, Disconnected: Recording is not available).
Clicking the arrow button (
by the device. You can check the input and output device's status (Record: During recording in the
Time-Lapse Recording or Event-Based Recording mode, Panic: During recording in the Instant Recording
mode, Idle: Ready to record).
Editing Input/Output Device Information
Click All Devices in the Site panel and then the arrow button (
List panel. Click the input/output device in the list of video in, alarm in/out and audio in/out supported by
the device. Clicking the
and selecting Edit Device from the menu displays the Edit Device window.
96
) beside each device name displays the list of inputs and outputs supported
button at the bottom of the Site List panel, or clicking the right mouse button
(Multiple Firmware Upgrade)
Click the
button at the top right corner and select
an upgrade file. If the device is a PC-based DVR,
check the PC Based DVR box and click the
button. The list of available devices is displayed.
Selecting Show all devices displays all registered
devices. Select devices and click the Upgrade
button at the bottom to start upgrading.
) beside each device name in the Site
Advertisement
Table of Contents
