Table of Contents
Advertisement
User's Manual
− Use NAT: Check the box when the NVR system uses a NAT (Network Address Translation) device
for network connection.
− Name: Enter the NVR system name to be registered on the DVRNS server. Check whether or not
the name is available by clicking the Check button.
NOTES:
The DVRNS (DVR Name Service) function allows the NVR system to use dynamic IP addresses for remote
connection. When using this function, you can access the NVR system remotely by using the NVR system
name instead of its IP address. For the DVRNS function to work properly, the NVR system should be
registered on the DVRNS server.
When LAN settings are changed, set up the DVRNS settings after saving your LAN changes by clicking
the OK button.
You will need to get the IP address or domain name of the DVRNS server from your network
administrator. You can use the domain name instead of IP address if you set up the DNS server during
the IP Address setup.
When using a NAT (Network Address Translation) device, refer to the NAT manufacturer's instructions
for the proper network settings.
The NVR system name you entered in the Name field should be checked by clicking the Check button,
otherwise the DVRNS changes will not be saved. When entering no name or a name already registered
on the DVRNS server, an error message displays.
SSL
2.3 Registering Devices
You must register devices on the administration service and add the devices to a device group in order to
perform any operation.
Run the iNEX Setup program.
12
Use SSL: Allows you to enhance the security of data
transferred between services of the iNEX program
by using the SSL (Secure Sockets Layer) protocol.
Using the SSL function might cause congestion in
the NVR system depending on the security level.
Log in the iNEX program again after you change
the setting. When the setting is changed, all services
that are currently connected to the administration
service reconnect, and the iNEX Setup and iNEX
Client programs are logged out.
Advertisement
Table of Contents
