Main Blower Vane Switch - Christie D4K35 Service Manual

5.12.8 Main Blower Vane Switch

The Main Blower Vane Switch is located on the bracket that supports the Main AC Blower.
(Estimated Replacement Time: 14 minutes + 10 minute LampLOC™ Alignment)
1. Remove the rear right skin. Refer to
(ignitor/blower
2. Remove the black and red leads. (Figure 5-60)
3. Using a 3/32" hex key, remove the two screws securing
the switch to the bracket.
4. Remove the switch from the bracket.
5. When installing, repeat instructions in reverse. Once
installed, perform LampLOC
refer to 3.3 Adjusting Lamp Position
D4K35 Service Manual
020-100817-01 Rev. 1 (04-2012)
5.4.4 Rear Right Skin
compartment).
alignment. For details,
™
(LampLOC™).
Section 5: Parts and Module Replacement
Figure 5-60 Blower Switch Leads
5-39