Christie D4K35 Service Manual page 110

Section 7: Serial API
Lamp Intensity Calibration (LEN) (Continued)
Main lens serial number
MSER
Not available
NONE
EXAMPLES:
(LEN+MMOD?L) List supported lens model
(LEN+AMOD?L) List supported auxiliary lens model
(LEN+MMOD 1 Set lens model
(LEN+MSER "xxxx") Set lens serial number
Lens Horizontal Position Adjustment (LHO)
Adjust lens offset to specific horizontal position with a specified direction. NOTE: This command can only be
used to update the current ILS file. Changing the horizontal offset for the current channel will change the horizon-
tal offset for any channel using the same ILS file.
Use command without subcode:
•
If ILS is ON, motor will move to specified steps and save data to the active channel.
• If ILS is OFF, motor will move to specified steps, do not save data to the active channel.
SUBCODE DESCRIPTION OF USE
Motor backlash in negative direction. Read-only.
BACN
Motor backlash in positive direction. Read-only.
BACP
Calibrate travel range and backlash on specified. Only valid parameter for this command is 1. Set only command.
CALB
Replace xxx with the channel number. Valid range is 101-164.
Cxxx
Moving lens mount to a specified horizontal position with a specified direction.
NONE
Motor moving range in negative direction. Read-only.
RNGN
Motor moving range in positive direction. Read-only.
RNGP
Move motor to the center flag then move back to current position. Only valid parameter for this command is 1. Set only command
RSET
Start motor moving in specified direction, where direction can be (-1, 1). Write-only for v1.3 or newer.
STRT
Stops the motor. Write-only for v1.3 or newer.
STOP
Moves the motor a given number of steps based on the current location. Write-only for v1.3 or newer.
MOVR
EXAMPLES:
(LHO 500 1) Move lens to position 500 along horizontal axis with positive approach
(LHO 500 -1) Move lens to position 500 along horizontal axis with negative approach
(LHO+C101 -500 1) Set lens horizontal position for channel 1 to -500 with positive approach
(LHO ?) Return current motor position along horizontal axis and direction (-1 or 1)
(LHO+CALB 1) Calibrate the horizontal axis
(LHO+RSET 1) Reset the horizontal axis
(LHO+STRT 1) Starts motor moving in positive direction
(LHO+STOP) Stops motor
(LHO+MOVR -100) Move motor 100 steps in negative direction
(LHO+MOVR 200) Move motor 200 steps in positive direction
7-10 D4K35 Service Manual
020-100817-01 Rev. 1 (04-2012)