Table of Contents
Advertisement
User ID (UID)
Allows users to login to the serial interface.
SUBCODE
DESCRIPTION OF USE
None
NONE
EXAMPLES:
(UID) "username" "password") Login a user
(UID) Logout the current user, also happens automatically when a new user logs in
(UID?)(UID! "username" 01) Display the current logged in user and their access level
Zoom Lens Position Adjustment (ZOM)
Adjust lens to specific zoom position with a specified direction (1, -1). NOTE: This command can only be used to
update the current ILS file. Changing the zoom for the current channel will change the zoom for any channel using
the same ILS file.
Use command without subcode:
• If ILS is ON, motor will move to specified steps and save data to the active channel.
• If ILS is OFF, motor will move to specified steps, do not save data to the active channel.
SUBCODE
DESCRIPTION OF USE
Motor backlash in negative direction. Read-only.
BACN
Motor backlash in positive direction. Read-only.
BACP
Calibrate travel range and backlash on specified. Only valid parameter for this command is 1. Set only
CALB
command.
Replace xxx with the channel number. Valid range is 101-164.
Cxxx
Moving lens mount to a specified vertical position.
NONE
Motor moving range in negative direction. Read-only.
RNGN
Motor moving range in positive direction. Read-only.
RNGP
Move motor to the center flag then move back to current position. Only valid parameter for this command
RSET
is 1. Set only command.
Start motor moving in specified direction, where direction can be (-1, 1). Write-only for v1.3 or newer.
STRT
Stops the motor. Write-only for v1.3 or newer.
STOP
Moves the motor a given number of steps based on the current location. Write-only for v1.3 or newer.
MOVR
EXAMPLES:
(ZOM 500 1) Move lens to position 500 with positive approach
(ZOM 500 -1) Move lens to position -500 with negative approach
(ZOM+C101 -500 1) Set lens zoom position for channel 1 to -500 with positive approach.
(ZOM ?) Return current motor position
(ZOM + CALB 1) Calibrate the zoom
(ZOM + RSET 1) Reset the zoom
(ZOM+STRT 1) Starts motor moving in positive direction
(ZOM+STOP) Stops motor
(ZOM+MOVR -100) Move motor 100 steps in negative direction
(ZOM+MOVR 200) Move motor 200 steps in positive direction.
D4K35 Service Manual
020-100817-01 Rev. 1 (04-2012)
Section 7: Serial API
7-27
Advertisement
Table of Contents
