Table of Contents
Advertisement
Section 5: Parts and Module Replacement
6. Swing the security ring out and disengage from the hinge.
7. Remove the four screws securing the hex driver holder plate above the cardcage assembly. (
8. Disconnect the harnesses from the cardcage fans. (Figure 5-33)
9. Disconnect the seven connectors from the Backplane PCB3G and LEQD. NOTE: The large power
connector is located at the rear of the cardcage.
10. Slide the cardcage back slightly, then pull it up and out to remove.
11. At this point, you can replace the entire cardcage assembly by repeating the above instructions in reverse
or replace individual boards.
12. When installing, repeat the above instructions in reverse.
5-22
Figure 5-33 Top of Cardcage
)
Figure 5-33
D4K35 Service Manual
020-100817-01 Rev. 1 (04-2012)
Advertisement
Table of Contents
