Christie D4K35 Service Manual page 108

Section 7: Serial API
Intelligent Light System Config (ILS) (Continued)
Move motor to center flag and then move back to current position. Only valid parameter for this command
RSET
is 5. SET only command.
Motor reset status (0-100%)
RSTS
EXAMPLES:
(ILS 1) Enable ILS, lens will be moved to the position in each channel
(ILS 0) Disable ILS, position data in each channel will not be used. Moving lens will not affect any channel setting
(ILS+CALB 5) Calibrate all axes of the lens. Set only command
(ILS+RSET 5) Reset all axes of the lens
(ILS+ACLB 1) Reset lens automatically when power on
Start Interrogator, check interrogator status (INT)
SUBCODE DESCRIPTION OF USE
Start a basic interrogation (set only)
BASC
Start an enhanced interrogation (set only)
ENHA
Responds with 2 values: currently running (1 if running) and result file.
STAT
EXAMPLES:
(INST+BASC 1) Run a basic interrogation (set only)
(INT+STAT?) Query interrogator status. Returns (INT+STAT!00100 00000 "Interrogator_Enhanced_20101103194849.7z"),
which means the interrogator is 100% finished, not currently running and the latest interrogator file that was generated is named
"Interrogator_Enhanced_201001103194849.7z" and can be found on the projector's FTP server.
Internal Test Pattern (ITP)
List and select internal test patterns. This command also creates the customized test pattern list from the internal
test patterns. The list of available test patterns is determined by what files are loaded on the TI electronics.
SUBCODE DESCRIPTION OF USE
Set(1)/Reset(0) full screen size
FULL
When KEEP=1, don't disable test pattern when changing channels
KEEP
NOCR set non-correction test patterns for measured color. Valid range is 0 to 6
NOCR
Select test pattern from full list of defined test patterns
NONE
Add test pattern from full list of defined test patterns to the user list
STUP
Select test pattern from user defined test pattern list
USER
EXAMPLES:
(ITP ?) Get current test pattern, 0 means no test pattern is used.
(ITP 4) or (ITP " ") Use number or string to set test pattern
(ITP+USER 4) or (ITP+USER " ") Use number or string to set test pattern from user's test pattern list.
(ITP+FULL 1) Use full screen size
(ITP+FULL 0) Use active channel screen file
(ITP+NOCR 1) Set non-correction test patterns for measured color you can use
(ITP+STUP "DC2K Framing Green, DC2K Framing Red") Add these two test patterns to the user list
(ITP+STUP 1 3) Add these two test patterns indexed in the ITP list to the user list
7-8 D4K35 Service Manual
020-100817-01 Rev. 1 (04-2012)