Flicker, Shadows Or Dimness; Lamploc™ Does Not Seem To Work; Liteloc™ Does Not Seem To Work - Christie D4K35 Service Manual

4.2.3 Flicker, Shadows Or Dimness

1. Ensure the douser is OPEN completely.
2. LampLOC™ may need re-adjustment.
3. LampLOC™ may be in the middle of its adjustment. Wait until LampLOC™ completes.
4. Adjust LampLOC™. In the Advanced Setup: LampLOC Setup window, tap the
5. Check the lamp power in the Advanced Setup: Lamp Power / LiteLOC Setup window to see if the
power is consistent or varying. Try to increase lamp power, if possible. Lamps which are near end of life
may not operate reliably at lowest power range.
6. Fold mirror misalignment (Christie service required).
7. Integrator rod misalignment (Christie service required).
4.2.4 LampLOC™ Does Not Seem to Work
1. If the Do Auto button of the LampLOC™ function does not work in
the Advanced Setup: LampLOC Setup window, try adjusting the
lamp position manually by tapping the
buttons in the LampLOC region. Watch the light level for changes
indicating lamp movement, both on the TPC readout and on screen
with a white test pattern.
2. If the motors do not respond, you can position the lamp manually. UV
danger. Qualified service technician only. Turn OFF and cool down
the lamp completely. Open the door with the proper safety equipment
and then manually adjust the motors to ensure that they are free and
moving smoothly.
3. If the lamp runs dim or the image displays poor uniform brightness, do
the following:
• Check that the anode yoke (lamp yoke) is in the correct position.
(Figure 4-2)
• Check that the flat part of the anode end of the lamp (if applicable)
faces up in the anode yoke. For CDXL-20 and CDXL-30 lamps, the flat part of the anode end of the lamp
should be positioned at the 2 or 10 o'clock position.
4.2.5 LiteLOC™ Does Not Seem to Work
1. In the Advanced Setup: Lamp Power/LiteLOC™ Setup window, ensure LiteLOC™ is enabled.
2. If the lamp power has increased to its maximum in order to maintain a LiteLOC™ setting, LiteLOC™ is
automatically terminated. If the values shown in the Advanced Setup: Lamp Power/LiteLOC™ Setup
window indicate that the lamp power has reached this "over-drive" state, either reduce your LiteLOC™
setting or install a new lamp.
D4K35 Service Manual
020-100817-01 Rev. 1 (04-2012)
up/down/left/right/in/out
Section 4: Troubleshooting
button.
Do Auto
Figure 4-2 Lamp Yoke Position
4-3