Table of Contents
Advertisement
Network Setup (NET)
Set the network parameters for Eth0, Gateway, and Subnet 0.
SUBCODE
DESCRIPTION OF USE
Set the IP address for the MGMT Ethernet controller (deprecated).
DLP0
Set the WAN IP address for the projector
ETH0
Set the WAN Gateway for the projector
GATE
Host name
HOST
Gets the MAC address of the projector
MAC0
Set the WAN subnet mask for the projector
SUB0
EXAMPLES:
(NET+ETH0 "192.168.1.35") Set new IP address on the MGMT Ethernet controller
(NET+GATE "192.168.0.1") Set the gateway
(NET+SUB0 "255.255.255.0") Set the subnet mask on the MGMT Ethernet controller
(NET+HOST "MyHostName") Set the host name
(NET+ETH0 ?) Retrieve IP address from the MGMT Ethernet controller. (NET+ETH0! 192.168.1.35)
(NET+MAC0 ?) Retrieve MAC address from MGMT controller. (NET+MAC0! 00:12:3F:7B:76:B4)
(NET+GATE ?) Retrieve default gateway. (NET+GATE! 192.168.0.1)
(NET+DLP0 "192.168.206.10") Set IP address (deprecated)
(NET+DLP0?) (NET+DLP0! "192.168.206.10") Query IP address (deprecated)
Projector Configuration File (PCF)
Set Projector Configuration File (PCF) file for the specified channel. This file is used to configure many aspects of
the electronics. It will only be used if PCF in use (PIU) control is set.
SUBCODE
DESCRIPTION OF USE
Replace xxx with the channel number. Valid range is 101 - 164.
Cxxx
Select PCF file for the current channel
NONE
EXAMPLES:
(PCF+C108 "SCOPE 2.39") Use PCF file "Scope 2.39" on channel 108. File used when PIU is on
(PCF?L) List all entries of PCF control
PCF In Use (PIU)
Select whether to use the PCF file or not.
SUBCODE
DESCRIPTION OF USE
D4K35 Service Manual
020-100817-01 Rev. 1 (04-2012)
Section 7: Serial API
7-17
Advertisement
Table of Contents
