11. Loosen the single thumbscrew securing the
light dump and remove.
12. Using the hex tool provided, loosen the
three captive screws securing the light
engine in place.
13. Using the built-in light engine handle,
carefully lift the light engine assembly out
of the projector. (Figure 5-42)
14. When installing, repeat above instructions
in reverse. Reshoot MCGD files, align the
aperture and adjust convergence. For
details, refer to
5.11 Power Supplies
D4K35 Service Manual
020-100817-01 Rev. 1 (04-2012)
Section 3 Service
Setups.
Figure 5-43 LVPS Compartment
Section 5: Parts and Module Replacement
Figure 5-42 Top View of Light Engine
5-27