Lvps/Lps Cover; Pib3G/Icp Cover - Christie D4K35 Service Manual

5.4.9 LVPS/LPS Cover

Remove the LVPS/LPS cover on the operator side (right) of the projector to access the lamp power supply
(LPS) connections, AC Relay and LVPS.
(Estimated Replacement Time: 4 minutes)
1. Using a #2 Phillips
captive screws from the top of the
cover. (Figure 5-8)
2. Lift the cover up just enough for the
bottom tabs to clear the frame and
remove.
3. When re-installing, align and insert
the bottom tabs first, then secure the
cover with the screws.

5.4.10PIB3G/ICP Cover

Remove the PIB3G/ICP cover to access the projector's communications/input panel.
(Estimated Replacement Time: 1 minute)
1. Push down on the cover's center tab.
(Figure 5-9)
2. Lift the cover up just enough for the
bottom tabs to clear the frame and
remove.
3. When installing the cover, insert the
tabbed end first then lift the cover
until the top tab clips into place.
D4K35 Service Manual
020-100817-01 Rev. 1 (04-2012)
, loosen the three
™
Section 5: Parts and Module Replacement
Figure 5-8 LVPS/LPS Cover
Figure 5-9 PIB3G/ICP Cover
5-9