Replacing The Fuse - High End Systems DL.3 User Manual

Replacing the Fuse

WARNINGS!
Disconnect power before servicing.
Replace fuses with the specified type and rating only.
Equipment surfaces may reach temperatures up to 130° C
(266° F). Allow the fixture to cool before handling.
The DL.3 has one user-serviceable fuse which controls mains voltage to the fixture.
To replace a fuse:
1. Disconnect power to the fixture. If the fixture
has been operating, allow the fixture to cool
before handling.
2. Loosen the 2 Phillips head screws on the top
cover of the connector side of the box.
3. Tilt the connector panel away from the box
4. Remove the fuse from the fuse holder.
5. Replace the fuse with a 5A, slow-blow fuse only.
6. Replace the side and top panels.
DL.3 Digital Light User Manual
CHAPTER 17
Maintenance and Troubleshooting
Fuse
307