Operating The Pto - New Holland T7030 Operator's Manual

SECTION 1 - - GENERAL INFORMATION AND SAFETY
12. Always select Position Control when attaching
equipment and when transporting equipment. Be
sure hydraulic couplers are properly mounted
and will disconnect safely in case of accidental
detachment of the implement.
13. If the front end of the tractor tends to rise when
heavy implements
three--point hitch, install front end or front wheel
weights. Do not operate the tractor with a light
front end.
14. Engage the clutch slowly when driving out of a
ditch, gully or up a steep hillside. Disengage the
clutch promptly if the front wheels rise off the
ground.
15. Ensure any attached equipment or accessories
are correctly installed, are approved for use with
the tractor, do not overload the tractor and are
operated and maintained in accordance with the
instructions issued by the equipment or
accessory manufacturer.
16. Remember that your tractor, if abused or
incorrectly used, can be dangerous and become
a hazard both to the operator and to bystanders.
Do not overload or operate with attached
equipment which is unsafe, not designed for the
particular task or is poorly maintained.
17. Do not leave equipment in the raised position
when the vehicle is stopped or unattended.
18. Do not drive equipment near open fires.
19. Always wear a protective mask when working
with toxic spray chemicals. Follow the directions
on the chemical container.
1--10
are attached to the
OPERATING THE P.T.O.
1. When operating P.T.O.- driven equipment, shut
off the engine, switch off the P.T.O. and wait until
the P.T.O. stops before getting off the tractor and
disconnecting the equipment.
2. Do not wear loose clothing when operating the
power take-off or especially when near rotating
equipment.
3. When operating
equipment, always apply the tractor parking
brake and block the rear wheels front and back.
4. To avoid injury, do not clean, adjust, unclog or
service P.T.O. driven equipment when the tractor
engine is running. Ensure that the P.T.O. is
switched off.
5. Make sure the P.T.O. guard is in position at all
times and always replace the P.T.O. cap when
the P.T.O. is not in use.
stationary P.T.O.-driven