Electronic Remote Control Valves; Control Lever Operation - New Holland T7030 Operator's Manual

SECTION 3 - - FIELD OPERATIONS
ELECTRONIC REMOTE VALVES
(where fitted)
NOTE: Electronic remote valves are only available
in conjunction with the Enhanced keypad.
The electronic remote valves (EHR) provide similar
functions to the mechanical valves previously
described. However, the electronic remote valves
have a number of additional automated features
which are supported by visual displays in the Dot
Matrix screen.
Transport Lock
The remote valves cannot be operated unless the
system is energised using the transport lock switch
(1). Depress the bottom of the switch to energise the
remote valve electrical circuit, depress the top of the
switch to disable the circuit.
When the transport lock is engaged (power off), the
amber warning light on the remote valve lever
console will illuminate and the valve(s) will be
disabled. To prevent inadvertent movement of the
implement when travelling between fields or on the
highway, it is recommended that EHR functions are
disabled.
119
IMPORTANT:The transport switch may also be used
to quickly stop operation of the rear remote valves.
Depress the top of the switch to isolate remote valve
operation, this has no effect on three- -point hitch
operation.

Control Lever Operation

At key--on all remote valves, levers and the joystick
(where fitted) must be in the neutral position. Any
control not in neutral will cause the corresponding
valve to be disabled, manually shift the control to
neutral to reactivate the valve.
If, during operation, a remote valve becomes stuck
in one position then the entire system will be disabled
until the fault is rectified or the valve electronically
disconnected from the system. Consult your
authorised dealer.
Each remote valve lever has four positions, Raise,
Neutral, Lower and Float. In Raise and Lower
modes, the detented positions are used for timed
remote valve functions.
3--75