SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION
Setting the Slip Alarm Point
NOTE: If the optional radar unit is not installed, the
slip alarm function will be omitted from the display.
The slip alarm point may be set as a one or two digit
figure that, if exceeded, will cause an audible alarm
to sound. To set a wheel slip limit of 15% carry out the
following procedure.
With the key--start in the ON position, depress
•
and hold the Menu/Enter key for 3 seconds. The
DMD will read SETUP_MENU, this will change
to CAL after 2 seconds. Using the Menu
Up/Down keys, scroll through the menu until the
wheel slip symbol (1) is displayed.
Depress the Menu/Enter key again to select the
•
set--up screen, a flashing cursor will appear at
the first number to be set. Using the Digit Value
key enter '1', move the cursor to the right with the
Digit Select key and, with the Digit Value key,
enter '5'. The slip alarm point is now set at 15%.
Touch the Menu/Enter key to memorise the
•
setting and return to the main menu.
If wheel slip exceeds the pre--set limit, the slip symbol
will appear in the DMD and the amber warning light
will illuminate on the instrument console.
Audible Beep - - ON/OFF
Each time one of the keys is pressed, an audible
'beep' sound will be heard. The beep can be switched
off if required.
With the key--start in the ON position, depress
•
and hold the Menu/Enter key for 3 seconds. The
DMD will read SETUP_MENU, this will change
to CAL after 2 seconds. Using the Menu
Up/Down keys, scroll through the menu until
BEEP ON/OFF is displayed.
Depress the Menu/Enter key again to select the
•
set--up screen. Using the Menu Up/Down keys,
align the arrow (1) with ON or OFF as required.
Touch the Menu/Enter key to store the setting
•
and return to the main menu. Depress the
Exit/Cancel key to return to the original display.
2--54
103
104